Surface Fixed Channels

#

Ties Restraints

 

Supplied with pre-drilled holes, WC36 channel can be fixed to timber, steelwork, masonry or concrete frames. The slim profile provides the added benefit of fitting within a standard 10mm thick mortar or movement joint. WC36 can also be welded to the under side of masonry support systems to accommodate soffit brickwork details.


Plain back channels can be surface-fixed to concrete and to steelwork, and in certain situations to masonry (normally as a wall starter for use with ties).


WC36 Surface Fixed Channel

special channel 2

 

WC28 Surface Fixed Channels

Wincro WC28P plain back channel can be supplied with holes or slots for fixing back to concrete or steelwork with appropriate fixings. Fixings should utilise a plate washer when fixing back to the frame.


The full range of Wincro WTS and WTP channel ties can be supplied for use with these channel systems. They are available from 75mm projection and can be supplied with the WDS plastic debonding sleeve for use in vertical movement joints.

 

For more information on suitable tie restraints, see our Channel Tie page.

 

wc28

WC27 25/14 Channel to SFS Studwork

Wincro’s WC27 SFS Channel system has been developed to fix back to steel studwork using the Wincro WBSDDZP screws to prevent any crushing of the insulation batts.

For further details on this particular system please see our Ties and Restraints Section).

wp27

 

Our Clients